Bandsaw Blades for Metal Recycling and Demolition
Scrap does not arrive clean, square, or clamped. Recyclers and demolition contractors cut painted pipe, mixed bundles, rebar-laced sections, and material nobody can identify. We spec the most damage-tolerant blades in the Arntz range and weld them in Hamilton to fit whatever saw does your dirty work.
What Slows These Shops Down
Unknown and mixed materials
The pile decides what you cut. A robust M51 variable pitch handles the widest spread of steel without a blade change per item.
Loose stock destroys teeth
Pieces that rotate or vibrate in the vise snap teeth off any blade. Clamping and bundling technique matter as much as blade choice, and we advise on both.
Coatings, scale, and contamination
Paint, galvanizing, and rust are abrasive. Hard M51 edges and a proper feed rate keep the blade cutting through the mess.
What We Cut For This Industry
- Pipe and casing
- Mixed bundles
- Structural demolition sections
- Tanks and vessels, sectioned
- Rail and heavy plate
- Machinery scrap
Blades We Recommend
Sprint Pro M51
The recycler's blade. M51 toughness and a forgiving geometry that survives interrupted, dirty, loosely-held cuts.
X-PRO M51
For processors doing volume on solids and heavy sections where blade life per tonne drives cost.
Sprint Plus M42
Budget option for clean, known mild steel scrap where the premium edge is not earning its keep.
Custom Welded In Hamilton
Every blade is loop welded to your machine's exact length at our Hamilton, Ontario facility and shipped across Canada and worldwide. Find your machine's spec or configure a blade now.
Find Blades For Your MachineFrequently Asked Questions
What is the best blade for cutting scrap pipe?
A variable pitch M51 like Sprint Pro with at least three teeth in the wall at all times. Clamp so the pipe cannot rotate; a spinning pipe strips teeth instantly regardless of blade.
Blades keep breaking on demolition steel. Why?
Hidden hardness and loose workholding are the usual causes. Old rail, spring steel, and hardfaced surfaces will chip bi-metal teeth, and anything that moves mid-cut shock-loads the band until it cracks. Slow down, clamp harder, and call us if a material keeps winning.
Is a premium blade worth it on scrap?
On mixed and dirty stock, yes: the M51 edge survives contact that kills economy blades, so you change blades less and cut more tonnes per dollar. On clean mild steel, Sprint Plus does the job for less.